Produktion | |

Installations | |

Documents | |

Dealers | |

Company | |

Kontakt |

Anlagenbau GmbH

65189 Wiesbaden, Park str 23, Deutschland

Tel: 0611 9005701

Fax: 0611 9005702

E-Mail: info@vmtec.de

**VMtec Maschinen-und Anlagenbau GmbH
Paderborn**

Sommerbrede 11,

D-33104 Paderborn, Deutschland

Tel: +49-5252-9170078

Fax: +49-5252-9333075

Mobil: +49-17670518235

E-Mail: a.friesen@vmtec.de

Skype: andreas.friesen1966

The choice of capacitor bank to install in a system is closely depended from:

- cosÏ•2 value that we would obtain

- cosÏ•1 starting value

- installed active power

By the following equation

where

Q_{C}= Required capacitors reactive output (kvar)

P = active power

Q_{L}, Qâ€™_{L} = Inductive reactive output before and after the installation of the capacitor bank

A, Aâ€™ =apparent power before and after the power factor correction.

The equation

can be also written

where the parameter k is easily calculable using table 1 below.

We have installed a load that absorb an active power of 300 kW with a beginning power factor 0.7 and we want to increase it until 0.92.

From the table 1 we find:

**Table 1**

and then we find

A typical example of power factor correction, sometimes not much considered but surely important, concerns the power factor correction of transformers for the distribution of energy. It is essentially a fixed power factor correction must compensate for the reactive power absorbed by the transformer in its no load condition (this happens often during the night). The calculation of the needed reactive output is very easy and it bases itself on this equation

where

I_{O}%= magnetising current of the transformer (AS%);

A_{N} = Apparent rated power in kVA of the transformer.

If we donâ€™t have these parameters, it is possible using the following table 2.

**Table 2**

Another very important example of power factor correction concerns asynchronous three-phase motors that are individually corrected. The reactive power we must install is reported on table 3.

**Table 3**

Be careful: the capacitor output must not be dimensioned too high for individual compensated machines where the capacitor is directly connected with the motor terminals. The capacitor placed in parallel may act as a generator for the motor which will cause serious overvoltages (self-excitation phenomena).

What about the wound rotor motor the reactive power of the

capacitor bank must be increased by 5%.